NRF 51822 wireless PIR sensor with Android camera

-


NRF 51822 is a very low power BLE System On Chip , that allows to use as Bluetooth Low Energy peripheral connected to Passive Infrared Receiver module.


PIR module used:


Schematic diagram of ble motion sensor:

HW build to 3D printed case:






Software for NRF51822 was developed with Arduino IDE:



NRF connect android application could be used  to check Bluetooth Low Energy  UART services and characteristics:



BleCameraNRF  android application is used to start motion detection  from Nrf51 module, check battery, temp and solar log.




Project files can be found from github:

https://github.com/joukohak/nrf51pir




Comments

Post a Comment

Popular posts from this blog

NRF 51822 BLE module sensor with Arduino IDE

-
Image
Radioland  BLE beacon module datasheet: https://www.renhotecic.com/image/download/pdf/2020031603025251822beacon.pdf can be reprogrammed with Arduino IDE and ST Link V2  to special remote button  application. SWDIO     ->   SWDIO SWCLK     ->   SWCLK 3.3V            ->   BAT+ GND          ->   BAT- 3D printed cover for BLE module:   Arduino IDE libraries for NRF51822  and instructions can be found from: https://github.com/sandeepmistry/arduino-nRF5 Nrf51822 Bluetooth low energy stack (Softdevice)  version S130 is required to download and flash to device  before BLE application software can be programmed : Selecting a SoftDevice SoftDevices contain the BLE stack and housekeeping, and must be downloaded once before a sketch using BLE can be loaded. The SD consumes ~5k of Ram + some extra based on actual BLE configuration...
Read more

BLE wireless motion sensor for surveillance camera

-
Image
BLE wireless surveillance camera with Android smartphone If you own Android smartphone with Bluetooth 4.0 and Android version min. 4.4(KitKat), you can easily change it to surveillance or hunting camera.     Just make PIR sensor(HC-SR501), BLE module (JDY-08) and STM8S103 microcontroller based   wireless movement detector .    This could be done easily without STM8S microcontroller using another BLE module with embedded IDE to develope software to communicate to Android application. Bluetooth Low Energy  wireless motion sensor Low power motion sensor consumes about 0,5 mA  on active BLE connection sleep mode. But it consumes 9 mA in active connection state, when motion is detected. Prototype hardware looks like this: Android applications(2 pcs) I have developed 2 Android   applications one to handle  BLE link to motion sensor and another to h...
Read more

BLE Freezer

-
Image
Bluetooth Low Energy module JDY-08 used in Low Energy Solar Fridge controller Bluetooth Low Energy module used in STM8S103 8-bit microcontroller based controller to use as Ultra Low Energy 12V Solar  Fridge from AC Freezer.    Modified sine wave inverter 1000W  including remote control interface modular RJ-11 connector.     Energy consumption has been with 60 l  Midea  freezer on 12 V  solar system about 8 Ah/ 24h. Printed Circuit Board is designed with KiCad tool and STM Visual Studio IDE used to STM8S103 firmware developement. BLE module used as wireless link to Android application developed on Android Studio. Graphic User Interface in Android application allows temperature setting, inverter control ,battery voltage show, fridge temperature show and voltage/temperature log graph show. Link to design files:  https://github.com/joukohak/solarfreezer
Read more